Camp Bandy Pet Resort
HOME
~
ABOUT US
~
BOARDING/GROOMING
~
TRAINING
~
EVENTS
~
STORE
~
CONTACT US
STORE
Build It Yourself Agility Equipment
Solo Standard Jump
Equipment
Saw, pipe cutter, or sawz-all
Drill
5/64" bit
Phillips head bit
PVC Cement
Tape measure/yard stick
Marker
Flat, hard surface
Parts
(one complete jump)
1 or 2 pieces 48" x 1" schedule 40 PVC (jump bar)
2 pieces 36" x 1¼" schedule 40 PVC (upright)
8 pieces 10" x 1¼" schedule 40 PVC (feet)
10 1¼" PVC pipe end caps
Jump Cups
to suit - 2 for each height
2 1¼" PVC
5-Way Crosses
#7 x ¾" roundhead or panhead screws (2 per cup)
colorful duct/tarp tape
Directions
Insert 10" pvc pieces (feet) into base of
5-Way Cross
Cap ends of feet
Insert 36" pvc piece (upright) into upright joint of
5-Way Cross
Cap upright
Place wing on flat surface and use tape measure and marker to mark height(s) for
Jump Cups
Height marks should be 1¼" below your desired jump height
Line "sighting hole" in
Jump Cup
to your height mark
Mark the two hanger holes in the
Jump Cup
onto your standard
Drill pilot hole(s) with 5/64" bit in the two corner holes
Attach
Jump Cup
with screws
Remove feet, place dab of PVC cement inside openings of the
5-Way Cross
base holes
one at a time
and re-insert feet. Optionally, glue upright into top of
5-Way Cross
Repeat steps 1-10 for second standard
Stripe Jump Bars as desired.
HOME
~
ABOUT US
~
BOARDING/GROOMING
~
TRAINING
~
EVENTS
~
CONTACT US
©2000 Camp Bandy. All Rights Reserved. Another
Redtail Design
site